With the development of Jinan automatic induction door enterprises, automatic doors can be seen almost everywhere. Automatic door is deeply loved by users because of its beautiful, simple shape, high cost performance and many other advantages. However, on the other hand, there are some disadvantages. Since automatic doors are frequently used in daily life, users need to pay attention to regular inspection in daily life. It is necessary to ensure its normal use at any time, but what details should relevant personnel pay attention to during automatic door inspection? How to check the automatic door?

1.，測試儀應以正常速度從門的外部或內部移動到自動門，自動門將自動打開。自動門動作平穩，無碰撞;自動門打開后，測試儀應以大約150mm-200mm/s的速度緩慢通過自動門，然后自動門應保持打開狀態;

1. First, the tester shall move from the outside or inside of the door to the automatic door at normal speed, and the automatic door will open automatically. The automatic door operates stably without collision; After the automatic door is opened, the tester shall slowly pass through the automatic door at a speed of about 150mm-200mm / s, and then the automatic door shall remain open;

2.檢查人員離開濟南自動門傳感器檢測區域后，自動門傳感器延時1-10秒自動關閉(延時可根據使用環境和流量合理設置，自動門動作平穩無碰撞;

2. After the inspectors leave the detection area of Jinan automatic door sensor, the automatic door sensor will automatically close after a delay of 1-10 seconds (the delay can be reasonably set according to the use environment and flow, and the automatic door will operate smoothly without collision;

3.觀察者以正常速度通過自動門的行走路線需要調整每日行走路線，使人面向自動門，而不是以一定角度朝自動門行走;當移動到自動門時，自動門傳感器的感應寬度范圍應大于整個門的寬度;

3. The observer's walking route through the automatic door at normal speed needs to adjust the daily walking route so that people face the automatic door rather than walking towards the automatic door at a certain angle; When moving to the automatic door, the sensing width range of the automatic door sensor shall be greater than the width of the whole door;

4.如果輔助安 全光傳感器安裝在自動門中，當自動門的門扇打開時，人們站著不動，用手蓋住輔助安 全光傳感器，門應保持打開。手離開后幾秒鐘內，門應再次關閉。

4. If the auxiliary safety light sensor is installed in the automatic door, when the door leaf of the automatic door is opened, people stand still and cover the auxiliary safety light sensor with their hands, and the door shall remain open. The door shall be closed again within a few seconds after the hand leaves.

濟南自動感應門需要檢查自動門的開啟和關閉速度、自動門的行走路線、門的靈敏度等?？傊?，檢查人員需要得到正確的結果，以保持自動門開啟和關閉的安 全，并做好工作，這樣每個人在使用時都會為安 全。

Jinan automatic induction door needs to check the opening and closing speed of the automatic door, the walking route of the automatic door, the sensitivity of the door, etc. In short, the inspectors need to get the correct results to keep the safety of opening and closing the automatic door, and do a good job in solving the problem, so that everyone will be safe when using it.