肯德基門聽字面意識就是到是肯德基店面的所裝的門，但是它還有另外一層意思，像是咖啡廳、、酒店等場所的門，在行業內都統稱為肯德基門，因?yàn)樗煨蜁r(shí)尚高雅、醒目大氣，所以很多的店面鋪?zhàn)右捕紩?huì)選擇肯德基門使用，那么你知道濟南肯德基門是怎么安裝的嗎？

KFC doors literally mean that they are the doors installed in KFC stores. However, they also have another meaning, such as the doors of coffee shops, shopping malls, hotels, and other places. They are collectively referred to as KFC doors in the industry. Because of their fashionable and elegant design, striking atmosphere, many stores also choose to use KFC doors. Do you know how Jinan KFC doors are installed?

一、安裝肯德基門的步驟

1、 Steps for installing KFC doors

1、清掃門洞

1. Clean the door opening

清理門洞，剔除多余部分、保證門框兩側都在垂直線上，清掃完成后在安裝門扇前也要在檢查一遍。

Clean the door opening, remove excess parts, and ensure that both sides of the door frame are on the vertical line. After cleaning is completed, it is also necessary to check again before installing the door leaf.

2、固定門框和地軸

2. Fixed door frame and floor axis

用螺絲或柳釘組合門框的三支型材，然后固定門框與墻體之間的連接，地軸需要行固定，固定地軸時從頂軸的中心線垂直地軸軸承的中心，在地面開出與地軸盒長、寬、高度相符的尺寸，用螺絲或水泥沙漿固定好地軸。

Use screws or willow nails to combine the three profiles of the door frame, and then fix the connection between the door frame and the wall. The ground axis needs to be fixed first. When fixing the ground axis, it should be perpendicular to the center line of the top axis to the center of the ground axis bearing, and a size that matches the length, width, and height of the ground axis box should be opened on the ground. Fix the ground axis with screws or cement mortar.

3、安裝肯德基門

3. Install KFC doors

松開肯德基門門扇上的防盜卡位螺絲，抽出上軸的軸心部分，在地軸軸承上抹上潤滑油保證門扇開合流暢，這樣做一定程度上可以增加門扇使用壽命。

Loosen the anti-theft locking screws on the KFC door leaf, pull out the axis part of the upper shaft, and apply lubricating oil on the ground shaft bearing to ensure smooth opening and closing of the door leaf. This can to some extent increase the service life of the door leaf.

4、調試門扇

4. Debugging the door leaf

若門扇的高低間隙有問題，可通過調試下軸上的內六角螺絲來調整，順時針調試可使門扇上升，逆時針調試則使門扇下降；要對門扇的方向進行調整，打開地軸盒的蓋板，用扳手調節地軸的螺絲就行。

If there is a problem with the high and low clearance of the door leaf, it can be adjusted by adjusting the inner hexagonal screw on the lower shaft. Clockwise adjustment can make the door leaf rise, while counterclockwise adjustment can make the door leaf fall; To adjust the direction of the door leaf, open the cover of the floor axis box and use a wrench to adjust the screws of the floor axis.

5、安裝閉門器

5. Install door closer

緊牢防盜卡位螺絲，進行閉門器的安裝，可根據閉門器配套說明書安裝并調試閉門器，閉門器調試完成無問題，就算安裝成功。下面來看看安裝肯德基門的注意事項吧。

Tighten the anti-theft detent screw and install the door closer. You can install and debug the door closer according to the door closer matching instructions. If the door closer is debugged without problems, the installation is successful. Let's take a look at the precautions for installing KFC doors.

安裝肯德基門的注意事項：

Precautions for installing KFC doors:

1、注意安裝的順序，不要出現裝好再拆的現象，各個地方的螺絲都要擰緊。

1. Pay attention to the installation sequence, do not install and then remove, and tighten the screws in all places.

2、在做安裝的清理工作時要到位，不要讓不該留的東西留在門洞或者門縫里。

2. When doing installation cleaning work, it is necessary to be in place and not leave anything that should not be left in the door opening or crack.

3、固定地軸的之后，等水泥干了進行下一步，保證堅固度。

3. After fixing the ground axis, wait for the cement to dry before proceeding to the next step to ensure firmness.

4、施工時，應嚴格做好產品保護，損壞的保護膠帶和保護膜應及時密封，濺在鋁門窗表面的砂漿污垢應及時。

4. During construction, product protection should be strictly carried out, damaged protective tape and film should be sealed in a timely manner, and mortar dirt splashed on the surface of aluminum doors and windows should be removed in a timely manner.

5、肯德基門安裝完成后要檢查對角線和平整度偏差，門進入后用鋼尺和塞尺檢查框扇的搭接寬度和周邊間隙，直符合要求。

5. After the installation of KFC doors is completed, the diagonal and flatness deviation should be checked. After the door enters, use a steel ruler and a feeler gauge to check the overlapping width and surrounding clearance of the frame and leaf until they meet the requirements.

我們?cè)诎惭b肯德基門時，可以使用以上方法來進行安裝，同時在安裝中要注意好安裝的順序，不要搞錯，施工中濺射在門窗上的污漬要及時干凈，免得影響美觀。您有安裝需求可以隨時來咨詢我們http://radiefmail.com！

When installing KFC doors, we can use the above methods for installation. At the same time, we should pay attention to the installation sequence and avoid making mistakes. The stains splashed on the doors and windows during construction should be promptly removed to avoid affecting the aesthetics. You can always consult us if you have installation requirements http://radiefmail.com ！