實際上當感應門運行時，有許多細節需要我們注意。因此，我們應檢查門體，并加強門的使用壽命。你知道感應門運行時需要檢查哪些細節嗎?你對此了解多少呢？下面一起來重新認識下它吧。

In fact, when the sensing door is running, there are many details that need our attention. Therefore, we should check the door body and strengthen the service life of the door. Do you know what details need to be checked when the induction door is running? How much do you know about it? Let's get to know it again.

感應門以其美觀、造型簡單、性價比高等諸多優點深受用戶的喜愛。然而，另一方面，也有一些缺點。由于感應門在日常生活中使用頻繁，用戶在日常生活中需要注意定期檢查。所以說我們要隨時確保其正常使用是必要的。

Induction door is deeply loved by users for its beautiful, simple shape, high cost performance and many other advantages. However, on the other hand, there are some disadvantages. As induction doors are frequently used in daily life, users need to pay attention to regular inspection in daily life. So it is necessary for us to ensure its normal use at any time.

1.測試儀應以正常速度從門的外部或內部移動到感應門，感應門將自動打開。感應門動作平穩，無碰撞;感應門打開后，測試儀應以大約150mm-200mm/s的速度緩慢通過感應門，然后感應門應保持打開狀態;

1. the tester shall move from the outside or inside of the door to the induction door at normal speed, and the induction door will open automatically. The induction door operates smoothly without collision; After the induction door is opened, the tester shall slowly pass through the induction door at a speed of about 150mm-200mm/s, and then the induction door shall remain open;

2.檢查人員離開門傳感器檢測區域后，感應門傳感器延時1-10秒自動關閉(延時可根據使用環境和流量合理設置，感應門動作平穩無碰撞;

2. after the inspectors leave the detection area of the door sensor, the sensor of the induction door will automatically close after a delay of 1-10 seconds (the delay can be reasonably set according to the use environment and flow, and the action of the induction door is stable without collision;

3.觀察者以正常速度通過感應門的行走路線需要調整每日行走路線，使人面向感應門，而不是以一定角度朝感應門行走;當移動到感應門時，感應門傳感器的感應寬度范圍應大于整個門的寬度;

3. the walking route of the observer passing through the sensing door at normal speed needs to adjust the daily walking route so that the person faces the sensing door instead of walking towards the sensing door at a certain angle; When moving to the sensing door, the sensing width range of the sensing door sensor shall be greater than the width of the whole door;

4.如果輔助光傳感器安裝在感應門中，當感應門的門扇打開時，人們站著不動，用手蓋住輔助光傳感器，門應保持打開。手離開后幾秒鐘內，門應再次關閉。

4. if the auxiliary safety light sensor is installed in the sensing door, when the door leaf of the sensing door is opened, people stand still, cover the auxiliary safety light sensor with their hands, and the door shall remain open. The door shall be closed again within a few seconds of the hand leaving.

濟南感應門需要檢查感應門的開啟和關閉速度、感應門的行走路線、門的靈敏度等?？傊?，檢查人員需要得到正確的結果，以保持感應門開啟和關閉的，并做好工作，這樣每個人在使用時都會為。

Jinan induction door needs to check the opening and closing speed of the induction door, the travel route of the induction door, the sensitivity of the door, etc. In short, the inspectors need to get correct results to keep the safety of opening and closing the induction door, and do a good job in solving the problem, so that everyone can be safe when using it.

以上就是今天為大家分享的關于問題的相關內容，希望對大家能有所幫助，想要了解更多內容可以電話聯系我們或者關注我們的網站http://radiefmail.com。

The above is the relevant content about the problem shared for you today. I hope it can help you. If you want to know more, you can contact us by phone or follow our website http://radiefmail.com 。